Skip to content
Replace an old furnace with a heat pump (339) 227-6907
HVAC Financing Medford logo
Copper water heater tank mounted on a green wall

Moving off fossil heat

Medford Boiler and Furnace Replacement With Heat Pumps

Retire oil, propane or gas equipment for a heat pump, with the old system handled according to program rules.

Replacing the Old System Without Budget Surprises

Many Medford homes still rely on an oil boiler, a propane furnace or gas equipment that is reaching the end of its service life. Replacing it with a heat pump gives the house one system for heating and cooling and ends fuel deliveries for oil and propane homes. The replacement has rules attached, and they affect both the budget and the rebate. For any zone the heat pump now serves, the program expects the old system serving that zone to be removed or disconnected. If you prefer to keep the old equipment as a backup, it must be connected to integrated controls that bring it on only during deep cold. We decide that with you at the planning stage and write it into the proposal, along with the cost of removal or control wiring, so nothing appears later as an extra. Capacity for the new system comes from calculating how the house loses heat today, which is often smaller than the old boiler's rating suggests. That keeps equipment costs in line. On installation we protect the work areas, keep the basement orderly and remove what comes out. At closeout we show you how the heat pump runs day to day and when the backup, if kept, takes over.

What the Replacement Scope Lists

Each house differs, but these items are common to most replacements.

  • Existing system survey

    Fuel type, age, zones and condition recorded so the scope reflects what is being replaced.

  • Right-sized equipment

    Capacity based on the home's current heat loss rather than the old unit's size.

  • Removal or disconnection

    The old boiler or furnace removed or disconnected for zones the heat pump serves.

  • Backup integration

    Integrated controls when the old system stays, limiting it to the coldest conditions.

  • Program paperwork

    Mass Save rebate and HEAT Loan documents prepared alongside the installation.

  • Operation walkthrough

    How the heat pump runs, when any backup engages and what routine care involves.

Replacement Steps

  1. Survey the current system

    An intake call, then a visit to document the boiler or furnace, the zones and the house.

  2. Choose removal or backup

    We settle it together, and the proposal lists the choice and its cost.

  3. Install and document

    Heat pump installed, the old system handled, everything tested and the paperwork filed.

Why Replacements Through Our Office Run Smoothly

  • Backup decided up front

    Removal or controls are settled before the proposal is signed, not on install day.

  • Rules followed for the rebate

    Old-system handling matches program requirements, protecting the rebate estimate.

  • Basement left orderly

    Removed equipment leaves with the crew and the work area is cleaned before closeout.

  • Oil, propane or gas
  • Removal planned
  • Backup controls
  • Rebate rules followed

Is Your Boiler or Furnace Near the End?

Tell us the fuel, the approximate age and how the house is zoned. We will outline what a heat pump replacement would include and cost to plan.